|
|
|
|
|
|
Fenix : CNC Working Center 5 Axes Interpolated
|
|
|
|
FENIXWC
|
|
|
|
The load bearing beam single-beam is made of very thick steel and has two robust hardened steel sliding tracks, so that the bridge sasw can work precisely for a much longer time. The bridge guide shoes are covered with tempered steel strips. We take a lot of care of the varnishing: sandblasting with an immediate treatment of varnishing with a zincing base before the workings. After the workings, washing and double varnishing. Push buttons pannel with easy-to-learn symbols insert on the floor electric board in a good position for the operator. Complete with the Tools' magazine with 12 linear stations + disc diam. 625, the machine can change automaticly the tools.
Disc bearing trolley's longitudinal travel mm. 3800
Transversal travel mm. 4900
Disc vertical travel mm. 1000
Electrospindle motor power with speed control from 0 to 6500 rpm that allows to use disc and tools that can be inclinated 200° KW 22
Automatic turning and continuous working table ± 360° mm. 3500 - 1800
Max disc diam. mm. 1100
X axis speed mm/min. 20000
Y axis speed mm/min. 20000
Z axis speed mm/min. 10000
A axis speed degrees/min.1800
C axis speed degrees/min. 600
Centralised lubrication controlled by PLC rails and bridge bellows
Laser
Software for disc and tools.
Equipment for the taking of shapes through laser with immediate reconstruction of the drawing to the computer
Automatic machine controlled by CNC type Micro 80 OMNIA (interpolating axes) and possibility to obtain all types of three-dimensional shapes, previously developed on personal computer.
Drivings:
The saw-blade holder slides on ball recirculation shoes, ensuring stability and precision for the tool.
The up and down movement of the blade is possible through a couple of tempered slides coated with antifriction and antiwear material and through a ball recirculation screw. That allows to obtain high precision in the saw-blade positioning and to absorb the vibrations.
The system is totally protected by bellows in order to avoid that dust and water spray compromise the long life of the bridge cutting machine.
Precision in the movement of the axes is obtained through vectorial motors and assured by coupling of grinded gears and racks with limited clearance.
Movements of cables: they are protected by strong and completely closed cable bearing chains.
The working table is automatic, programmable in positions from 0 to 360° and with continuous rotation with system to control the clearance.
The oleodinamic brakes ensure a safe full positioning.
|
|
|
|
|
|
|
|
|
|
|
